Rainbow Coatings of Michigan
Bringing the highest quality of architectural finishing

Quality Specifications - AAMA 2605 – Kynar 500®

Parts are received from customer

All parts are visually inspected for damage

All parts are counted and matched to “Quoted Material

Pre-treat process

5 Stage AAMA 2605 pre-treat

Bulk Chemical is the pre-treat supplier

Representative parts are sent on a regular basis to our pre-treat supplier (Bulk Chemical) and to our paint suppliers (Valspar, PPG, Akzo) for quality spot checks.

After painting

Visual: inspect for imperfections, color uniformity and color match to be consistent with the color range or numeral value.

7.2.1 Specular Gloss: with gloss meter, in accordance with ASTM D 523 Gloss values with in +- of 5 units of spec.

7.3.1-Dry Film Hardness: from Berol Eagle Turquoise pencil (grade F minimum)

7.4.1.1Dry Adhesion: parallel cuts made, tape applied and pulled off. Pieces should be at ambient temperature of 65°F to 80°F (Crosshatch)

7.4.1.2Wet Adhesion: Immerse samples in distilled water at 100°F for 24 hours, repeat test

7.4.1.3 Boiling Water Adhesion: Immerse sample in boiling water for 20 minutes

7.5 Impact Resistance: Using Gardner Impact tester

MEK Rub Test

Parts are wrapped and shipped to customers specifications

Paint Suppliers
Valspar
PPG
Akzo